Kraus - ST-PB-01 - T-Rex Pull Back Plate - Fits 2000-2026 Harley-Davidson Touring

Fitment

Fitment notes:

• Suggested for use on Street Glides and Electra Glides but can also be used on other Harley's including Road Glides with modification.
• When running the Kraus T-Rex pullback plate you CAN NOT use your stock Key Switch/Steering Lock so you will need to relocate the switch or fully remove it with an optional CVO Ignition Flash done by your local HD dealer. Check with your local shop or dealership for options.
• If you ARE running Kraus Isolated Risers then this kit has everything you need to have the most solid and best-performing setup.
• If you ARE NOT running Kraus Isolated Risers you will need a set of replacement Bagger Polyurethane Bushings to install under your risers in the T-rex Plate.
• 2024+ Models will contact factory nacelle. Can be installed with Kraus Trees however
• The total hand position height of this setup measured from the top of the stock triple tree is listed below.
• NOTE: The T-Rex adds 1" to the total height to a Kraus Isolated Riser and Bar setup.
• 8" Riser option with Fly Bars = 10.5" total
• 10" Riser option with Fly Bars = 12.5" total
• 12" Riser option with Fly Bars = 14.5" total
• 8" Riser option with ODI Bars = 12.5" total
• 10" Riser option with ODI Bars = 14.5" total
• 12" Riser option with ODI Bars = 16.5" total
• Downloads Product Guide, Batwing Nacelle Cut Template