Replica smooth rear fender is one piece and has three drilled holes for struts. Uses Tombstone or Beehive tail lamp. Fender is equipped with clips on the underside of the fender for the tail light wiring. We suggest pre fitting the fender prior to painting. Before priming or painting, fit the fender body, braces and mounting points in place. Fender rivets, hinge and brackets will have to be tweaked for final fitment. Patience is required for proper installation! *Note: UPS may consider this part as packaged "oversize" for shipment, as compared to the actual weight, which will result in higher shipping costs.
V-Twin - 50-0704 - Replica Rear FenderDescriptionReplica rear fender accepts tail lamp. Uses either stock or smooth struts.We suggest pre fitting the fender prior to painting. Before priming or...
V-Twin - 50-1021 - Replica Rear FenderDescriptionReplica fender rear has tail lamp cutout and is 7-3/4" wide. Fender has indent for turn signal bar and uses tail lamp.We suggest pre fitting the...
V-Twin - 50-0187 - Replica Rear Fender SteelDescriptionReplica fender is constructed of steel and has a cutout for the tail lamp. Fender mounts to stock struts.We suggest pre fitting the fender prior...
V-Twin - 50-0768 - Replica Rear Fender RawDescriptionReplica rear fender is constructed of steel and has a raw finish.The width of the fender is 7-1/2". We suggest pre fitting the fender prior to...
V-Twin - 50-0767 - Replica Rear Fender RawDescriptionReplica smooth rear fender.For use with custom tail lamp. Tail lamp hole must be cut out. Fender is not equipped with indents for signals. We...