Electra Glide FLH

Assembly includes harness pre-wired to dash base, a six post key switch, terminal box, horn button, dimmer switch, headlamp connection, speedometer lamp socket, and front terminal board. Assembly is...

Odometer reset knob is equipped with a screw for 2:1 and 1:1 ratio speedometers. Fits:FL 1968-1984Additional Information OEM No.67215-68 <

Speedometer adapter ring kit will mount 3-3/8" O.D. tachometer, speedometer or 85mm GPS speedometer. Kit includes chrome adapter ring and bracket.For stamped steel 2 and 3 light cateye dash panels,...

Ignition switch spacer is .040" thick.Spacer is for spacing dash base and switch in relation to tanks. Fits:FXST 1984-1995FL 1941-1984FLST 1986-1995Additional Information

Chrome tank panel is plain, smooth style, and fills the gap between 3.0 and 5.0 gallon bobbed type tanks. Mounts under steel two and three light dash panel, and with large O-ring. Fits:FL...

Speedometer has a ratio of 1:1 and features a black face with Stewart Warner police special graphics, white 0-100 mph numbering and red needle.Speedometer comes fully assembled with Stewart Warner...

Speedometer has a ratio of 1:1 and features a black face with Stewart Warner police special graphics, white 0-120 mph numbering and red needle.Speedometer comes fully assembled with Stewart Warner...

Stewart Warner police speedometer tin face features all black background with 0-100 mph white numbering for use with 2:1 or 1:1 ratio speedometers.The speedometer must be disassembled to install this...

Stewart Warner police speedometer tin face features all black background with 0-120 mph white numbering for use with 2:1 or 1:1 ratio speedometers.For use with 1:1 or 2:1 ratio V-Twin MFG mechanical...

V-Twin - 39-0014 - 85mm GPS Speedometer Tachometer GaugeDescription85mm gauge with chrome bezel, 0-120 mph, built in tachometer and GPS speedometer. Gauge uses a remote sensor pad which must be...

V-Twin - 38-1959 - FL 3.5 Gallon Gas Tank SetDescriptionBobbed gas tank kit includes a 3.5 gallon capacity gas tank set with emblem mounts welded in place. Kit includes 1959 - 1960 emblems with...

Gas cap set features a vented and non-vented gas cap with krommet covers. Fits:FL 1965-1982Additional Information UOM1 - SET

Bobbed 5 gallon gas tank features brackets welded in place to accept 1963-1965 emblems. Set include Eagle Iron brand emblems and chrome cap set. Gas tank accepts left side 22mm petcock with nut.For...

V-Twin - 38-0627 - 1966 Fat Bob Gas Tank Set 3.5 GallonDescriptionBobbed gas tank set has a fuel capacity of 3.5 gallons. Includes emblem mounts welded in place, 1966-1971 emblems with screws and a...

V-Twin - 38-0568 - 1966 Fat Bob Gas Tank Set 5.0 GallonDescriptionBobbed gas tank kit includes 5 gallon gas tank set with 1966-1974 emblems with screws, gas cap set, and emblem mounts welded in place...

Description Bobbed gas tank kit includes 5 gallon gas tank with 1966- 1971 emblems with screws, gas cap set, and emblem mounts welded in place.For foot shift applications. Acecepts 3/8" NPT petcock...

Deluxe chrome gas cap replaces bayonet type early caps. Gas cap is non-vented. Fits:FXS 1979-1982FL 1941-1982Additional Information UOM1 - EA

Chrome front brake cable clamp has a 1" inner diameter. Fits:UL 1937-1948VL 1930-1934J 1928-1929FL 1941-1986EL 1936-1940WL 1929-1952Additional Information

Center kickstand spacer. Fits:FL 1971-1984Additional Information OEM No.5905 UOM5 - PK

Chrome frame hole plug. Fits:FL 1968-1984Additional Information OEM No.68797-68A UOM10 - PK

Saddlebag lower mount clip kit, includes 4 clips, 20 pop rivets and 8 plates to attach to bags. Fits:FL 1970-1980Additional Information OEM No.90949-63A<

Transmission bearing retainer screws measure 1/4"-24 x 13/16" and features a zinc finish.Sold as a pack of 10, in a Zinc finish. Fits:UL 1937-1948FX 1971-1979EL 1936-1940FL 1941-1979Additional...

Adjustable top triple tree tee bolt set.*NOTE: Lock tabs not included, must order separately. Fits:FLH 1949-1984Additional Information OEM No.45752

Hex type screw is 1/4" x 20 x 1-1/4". Fits:UL 1937-1948FX 1971-1984EL 1936-1940FL 1941-1984Additional Information OEM No.3993<

Alternator mount screw with lock patch is 10-24 UNC x 1". Fits:FL 1970-1984FX 1970-1984FXST 1984-1986FLST 1986-1986Additional Information

Kit includes stud, nuts, nylon washer, and acorn nut. Fits:FXDWG 1991-1995FXST 1984-1995FLST 1986-1995FX 1980-1986FL 1968-1984Additional Information

Saddlebag hardware kit includes hinge set, side straps, latch set, lock with catch, bottom spring clips, rivets, reinforcing plates, and rubber gasket. The kit can be used for either the right or...

Spacers for fender trim rails. Fits:FL 1948-1984Additional Information OEM No.91089-58 UOM4 - PK

Steering Damper Anchor Plate Frame Pin Fits:FLH 1949-1984Additional Information OEM No.46731-48 UOM1

Chrome slotted transmission fill plug. Fits:UL 1937-1948FX 1971-1984EL 1936-1940FL 1941-1984Additional Information UOM1 - EA

Slotted transmission fill plug. Fits:UL 1937-1948FX 1971-1984EL 1936-1940FL 1941-1984Additional Information UOM1 - EA

V-Twin - 37-9079 - Skull Pushrod Cover Cup Set GoldDescriptionGold plated skull pushrod cover cup set.Sold as a 4 piece set. *NOTE Gold plate is very delicate. Do not Polish. *No warranty or returns...

Stock oil pump plug with slot Fits:FX 1971-1980FL 1968-1980Additional Information OEM No.26377-68 UOM

Chain tensioner screws has phillips flat head Fits:FXD 1991-2005FLST 1986-2006FXST 1984-2006FL 1965-1984FX 1971-1984FLT 1984-2005FXR 1984-1994Additional Information

Clamps the cable to the frame.This clamp may also be referred to an ignition wire clamp on late 1978-1979 FLH models, or a circuit breaker wire clamp on 1970-1979 FL, FLH models. Fits:FLH 1978-1979FL...

Alternator mount screws with lock patch are 10-24 UNC x 7/8" . Fits:FL 1970-1984FXR 1984-1988FLT 1984-1988FX 1971-1984FXST 1984-1988FLST 1986-1988Additional Information

Tee bolt front fender trim rail Fits:FL 1961-1984Additional Information OEM No.91091-61 UOM5 - PK

Chrome spotlamp bar hole plugs Fits:FL 1968-1984Additional Information OEM No.68797-68 UOM10 - PK

Chrome die cast spark plug cover fits perfectly on a spark h ex for Big Twin 14mm pre 1999 models. Fits:FXST 1984-1999FXD 1991-1999FXR 1982-1994FLST 1986-1999FX 1971-1984FLT 1979-1999XL 1957-1985FL...

Stainless steel handlebar master cylinder cover screw Fits:XL 1972-1981FL 1972-1981FX 1972-1981Additional Information OEM No.2628<