Description
Nickel plated eclipse front hub has 36 holes and is retrofitted with 2 sealed ball bearings and 2 cone spacers to give the hub the correct width.
Hub is retro fitted with sealed ball bearings, inner spacer tubes and two collars which act as a cone. The center tube is installed between the 2 bearings. Spacers included. *NOTE: Includes 3/8" axle with 2 hex nuts and 2 flat washers.
Fits:
- F 1910-1915
Additional Information
| UOM | 1 - EA | |||||||||||||
| Measurements |
Finish | Nickel Plated | Location | Front | Material | Steel | Origin | Imported | 2025 Catalog Pages | 826 | Tech Note | Suggested to use with #44-0761 3/8" Front Axle. Related ProductsRelated Products  V-Twin - 45-0985 - Front or Rear Wheel Hub Nickel Plated - Fits 1930-1936 Harley-Davidson VLV-Twin Mfg
$203.67
Nickel plated front or rear wheel hub is for use with 18" and 19" rims.Sphere is 12 tooth and 10mm deep with a total length of 56mm. The sphere starts at 7.7mm from the edge. ...
Out of stock
  V-Twin - 35-7135 - Schebler Carburetor Rebuild Kit - Fits 1910-1915 Harley-Davidson FV-Twin Mfg
$239.92
Round type Schebler carburetor rebuild kit fits "H" model Schebler carburetors.This kit includes a small round float, float arm, pin and needle with seat. Fits:F 1910-1915Additional Information
Out of stock
  V-Twin - 45-0109 - WR Front Spool Hub Nickel Plated - Fits 1936-1952 Harley-Davidson WV-Twin Mfg
$254.34
WR front spool hub is nickel plated with 40 holes and accepts stock WL front wheel internals.*NOTE: This is the original design of the Private or Privateer Raders of the 1940's. They use the two...
 V-Twin - 44-0761 - 3/8 inch-20 Zinc Front Axle - Fits 1910-1915 Harley-Davidson FV-Twin Mfg
MSRP:
$43.51
$42.64
3/8"-20 front axle includes 2 nuts and 2 washers. The ends are both threaded to fit models with eclipse front hubs. For Spring Forks.*NOTE: Must order 3/8"-20 spacers as required. Fits:F...
  V-Twin - 35-9157 - Early Schebler Round inchH inch Float - Fits 1910-1915 Harley-Davidson FV-Twin Mfg
$90.75
Early Schebler small round "H" carburetor float. Includes brass screw and shouldered sleeve nut.The duck stops here! Float is molded of 100% nitrophyl material, unsinkable! *NOTE: Not for oxygenated...
|